AlfaRadio AlfaSpid Rotator and Controller Manuel d'utilisateur télécharger pdf (Page 2)

lfa Radio Ltd.

11211 - 154 St. Edmonton, Alberta, Canada T5M 1X8

[email protected] 780 466 5779 www.alfaradio.ca

Page 2 of 18 ~alfaspid/

AlfaSpid_MD-01_Setup_05Sept2013_Master.doc

· Go to Set Protocol

Using Ethernet Communications :(If Ethernet module is installed)

· When power is turned on the MD-01 display shows: ”Mode: Normal”.

· Press button: S twice

· You will now enter “Motor configuration”

· Press button: “>” ~ 8 times. Then select “ETH” with the up or down buttons

Set Protocol

· Press button: “>” 1 time again and select SPID ROT2 with the up or down buttons

(protocol SPID ROT2) (The SPID ROT2 protocol is installed as a standard protocol in

the MD-01 rotator controller)

1 2 3 4 5 6 7 ... 17 18

Pas de commentaire

AlfaRadio AlfaSpid Rotator and Controller Manuel d'utilisateur Page 2